None 5402 Instalační příručka

Procházejte online nebo si stáhněte Instalační příručka pro ne None 5402. none 5402 Installation Guide Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 1
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
6'' MINIMUM
LADIES’ ROOM-53 1/4''
MEN’S ROOM-58 1/2''
FROM FLOOR
INSTALLATION INSTRUCTIONS
Clean Hands
®
Sanitary Door Openers are
recommended for all pull-open, washroom, exit
doors; however, they should not be installed where
the backward swing of a door could contact an
unsuspecting person using a lavatory, towel dispenser
or other washroom equipment.
1. Lightly mark a door for a Ladies’ Restroom 53 1/4
inches from the floor and for a Men’s Restroom
58 1/2 inches from the floor. These marks are
for the top of the Openers. If needed, increase the
installation height for the Ladies’ restroom slightly
to maintain a six-inch minimum clearance
between the top of the conventional door handle
and the bottom of the Sanitary Door Opener. For
special situations, install the top of the Openers at
shoulder height.
2. Insure that the screws provided are suitable for the
door thickness. If installation is on a metal or fire
rated door, through bolts (not provided) must be
used.
3. Place Opener 1/4 inch back from the door edge
and mark the four hole locations. For metal doors,
increase this set-back so that bolt heads will not
interfere with the door “stop”.
4.
Prepare a 9/64-inch diameter drill bit for drilling pilot
holes for the screws. Place a drill stop on the bit or
place tape around it to indicate when the drill depth
is 1/4 inch less than the length of the screws.
5. Keeping a drill level, drill the two outside pilot
holes. Drill the top inside pilot hole slightly
downward. Drill the bottom inside pilot hole slightly
upward. DO NOT DRILL PAST EDGE OF TAPE.
6. Install Opener on the door. END OF SIDE WITH
HOLES MUST FACE DOOR EDGE.
7. Install the wall sign either on the wall adjacent to
the Opener or on the door about one inch above
the Opener. Press firmly over the entire sign to
achieve good adhesion. (A reverse image of the
wall sign is not provided.)
8. REMOVE BURRS VERY IMPORTANT
Using a hand file or powered abrasive point,
remove all burrs from the screw heads resulting
from the installation. Relocate existing door
bumper or install new bumper (not provided) to
protect adjacent wall from Opener strikes.
6
OR
8
5
4
3
2
9/64"
1/4"
1/4"
ANGLE SLIGHTLY DOWNWARD
ANGLE SLIGHTLY
UPWARD
DOOR EDGE
1
7a
7b
Zobrazit stránku 0
1

Shrnutí obsahu

Strany 1 - INSTALLATION INSTRUCTIONS

6'' MINIMUMLADIES’ ROOM-53 1/4''MEN’S ROOM-58 1/2''FROM FLOORINSTALLATION INSTRUCTIONSClean Hands® Sanitary Door Opener

Komentáře k této Příručce

Žádné komentáře